Transmitter Configuration

First of all the basic procedure. Below you will find examples of the most common connection variants.

• create a new fixed-wing model in your transmitter
  • If you want to create the new model as a helicopter, set the swashplate mode to H1, i.e. without a swashplate mixer. You do not need the throttle channel in the simulator, as you define the rpm in the model settings of the helicopter. The collective pitch channel is used as a throttle channel for wing models. The motor-off switch should switch its own channel. It must not influence any of the channels used for the 4 main control functions.
  • In rare cases, the control signal is not transmitted smoothly to the computer. Then simply connect the USB adapter directly to the computer and not through a hub. This usually solves the problem.
• remove all other joystick devices or usb simulator adapters
• Connect the transmitter to the computer either directly or via a USB adapter. We recommend using wireless adapters such as the RX2SIM.
• start neXt - CGM RC Flight Simulator
• press esc and change to the settings > input device tab

The control input monitor window displays the raw control signal data. Up to 20 channels are possible depending on your dongle or adapter. Each function (collective pitch, rudder, aileron and elevator) should move a slider. If not, please follow the instructions below. the perfection filmyzilla upd

• then click on start calibration and follow the instructions there
• select your stick mode also in settings > output device